- Screw-on design eliminates any leakage or dripping of product.
- Non-lubricated, pre-lubricated at the factory.
- Very simple design, with parts common to most models.
- Fewer parts than the competition.
- Materials available: Polypropylene or PVDF or Aluminum or Stainless Steel 316
- It is self-priming without seals.
- Can be mounted as a submersible pump.
- The pump is not damaged by dry running or against a closed valve on the discharge side.
- Can be mounted in ATEX classified areas, the metallic range.
- Withstands solids and abrasives well
- Easy to repair.
- Low acquisition cost.
- The ¼”, ½”, 1″, 1.5″ or 2″ model will have an aluminum center section or a polypropylene reinforced fiberglass mold. , 1.5″ or 2″ will have the central section in aluminum or a mold in fiberglass reinforced Polypropylene. The ¼” model will only be manufactured in plastic materials.
The 3″ model will only have the center section in aluminum.
We have stock of most models, in 24 or 48 hours we can deliver the FTI Air pump from the factory directly to the customer.